Moby Marine, LLC
gomobymarine@yahoo.com
Lock-n-Haul®
• The Lock-n-Haul® transom saver is the world's first and only 4-point inline load universal fit outboard boat motor support made specifically for trailering. It easily adjusts to fit ALL outboard motor brands including most models and sizes with power tilt systems, on ANY BOAT. Width of setback or jackplate don't matter at all.
• The Lock-n-Haul® transom saver doesn't need flimsy ‘steering clips’ that keep your motor straight (but not rigid)…. it has no moving parts to wear out….no loose, weak, (offset load) spring-loaded pins, that move and bend and allow the motor to shake….and it has no (short life) rubber cups, that have to be fully compressed to even begin to stop the motor from shaking. - "Compare it to any other product"
• The Lock-n-Haul® transom saver is a one piece device that completely stabilizes the outboard motor and stops all harmful motor movement, by locking both the tilt and steering pivots. Convenient to stow in a small boat compartment when not in use.
• The Lock-n-Haul® transom saver is 100% machined to be a tough compact (13"x9"x1" footprint), lightweight (less than 1 pound), simple and effective device, and carries a two year warranty against manufacturing and material defects.
• Includes a quick clip, coated aircraft cable retaining lanyard, has an anodized coating on the aluminum, and the steel sleeve is e-coated for superior anti-corrosion protection that won't rust and is safe for fresh water and saltwater use.
***IMPORTANT***
PLEASE READ THIS BEFORE YOU BUY
Three features are necessary to install the Lock-n-Haul on your outboard motor.
1) Power outboard motor tilt system
2) Accessible (lower motor mount) steering pivot rod flange bolt heads
3) Transom motor mount indents/concaves
*** Long shaft (offshore) motors with 25"-30"shafts ***
See picture at bottom of this page and compare to your motor.
Yamaha outboard features - Yamaha outboard features - Yamaha outboard features
Power outboard motor tilt Accessible (lower motor mount) steering Transom motor mount indents/concaves
pivot rod flange bolt heads
Mercury outboard features - Mercury outboard features - Mercury outboard features
Power outboard motor tilt Accessible (lower motor mount) Transom motor mount
steering pivot rod flange bolt heads indents/concaves
Evinrude outboard features - Evinrude outboard features - Evinrude outboard features
Power outboard motor tilt Accessible (lower motor mount) Transom motor mount
steering pivot rod flange bolt heads indents/concaves
The Lock-n-Haul on a long shaft
The Lock-n-Haul® is 13" long. The ends are 7/8" diameter and the tubes are 3/4" diameter. Tilt your motor until you have 13" between the steering pivot rod flange bolt heads, and the indents/concaves on the transom mounting bracket. If you can put a 3/4" diameter tube between them then it will work on your motor.
You can also use the picture above as a quick reference. Basically the flange bolt heads and the motor mount features need to line up when the motor is vertical.
Copyright © 2012 - Lock-n-Haul®
